Subscribe to Our Youtube Channel
Related Manuals for Draper STORMFORCE OMT3003DSF
Summary of Contents for Draper STORMFORCE OMT3003DSF
- Page 1 Original Instructions Version 3 February 2025 230V OSCILLATING MULTI-TOOL 58288...
-
Page 2: Table Of Contents
6.2 Fitting the Sanding Accessories 7. Basic Operation 1.4 Copyright © Notice 7.1 ON/OFF Switch 7.2 Variable Speed Control Copyright © Draper Tools Limited. 7.3 Basic Operation Permission is granted to reproduce this manual for 8. Maintenance personal and educational use ONLY. Commercial 9. Spares, Returns and Disposal copying, redistribution, hiring or lending is strictly 10. -
Page 3: Product Introduction
Any other application beyond the conditions established 4.1 General Power Tool Safety Warnings for use will be considered misuse. Draper Tools accepts no responsibility for improper use of this product. WARNING! Read all safety warnings,... - Page 4 • DO NOT abuse the cord. NEVER use the cord for • If devices are provided for the connection of dust carrying, pulling or unplugging the power tool. extraction and collection facilities, ensure these are Keep cord away from heat, oil, sharp edges or connected and properly used.
-
Page 5: Additional Safety Instructions For Oscillating Multi-Tools
If the power supply cord is damaged, it must be replaced by Draper Tools, an authorised service agent or similarly qualified personnel in order to avoid a hazard. The damaged or incomplete plug, when cut from the cord, shall be disabled to prevent connection to a live electrical outlet. -
Page 6: Identification And Unpacking
If any part is damaged or missing, do not attempt to use the product. Please contact the Draper Helpline; contact details can be found at the back of this manual. Hook and loop sanding backing pad (13) 10. -
Page 7: Preparation Instructions
6. Preparation Instructions Important: Before preparing or adjusting this product, 3. Place the required accessory (11) or (12) onto the read and understand all the safety instructions listed in flange (4), aligning with the four locating pins on the this manual. flange seating. -
Page 8: Fitting The Sanding Accessories
6.2 Fitting the Sanding Accessories – 3. Place the sanding backing pad (9) onto the flange (4), aligning with the four locating pins on the flange Fig.5 -Fig.9 seating. 4. Fit the retaining disc (6) and then the locking bolt (5). (13) (13) Fig. -
Page 9: Basic Operation
7. Basic Operation 7.2 Variable Speed Control – Fig.11 Important: Before operating this product, read and understand all the safety instructions listed in this manual. Ensure that the product is fully assembled and correctly prepared for use. WARNING! 7.1 ON/OFF Switch - Fig.10 Fig. -
Page 10: Maintenance
Draper Tools will endeavour to hold any spare parts, if alterations, accidents, or repairs attempted or made by applicable, for seven years from the date that it sells the any personnel other than the authorised Draper Tools final matching stock item. -
Page 11: Explanation Of Symbols
10. Explanation of Symbols 3¡ 3° Oscillating angle Read the instruction manual Accessory attachement Wear face mask and safety glasses fitting profile Class II construction Wear ear defenders (Double insulated) WEEE – Wear protective gloves Waste Electrical & Electronic Equipment Do not dispose of Waste Electrical &... -
Page 12: Contact Details
Product Helpline: +44 (0) 23 8049 4344 Telephone Sales Desk: +44 (0) 23 8049 4333 General Enquiries: +44 (0) 23 8026 6355 Please contact the Draper Tools Product Helpline for repair and servicing enquiries. © Published by Draper Tools Limited © Published by Draper Tools Limited...
Need help?
Do you have a question about the STORMFORCE OMT3003DSF and is the answer not in the manual?
Questions and answers