Advertisement
Quick Links
10751 Instructions
12/2/02
5:20 PM
WARNING:
The Health and Safety Executive recommend in
their document HS(G)17 that grinding is only
performed on the face of the grinding wheel
and not on the side of the wheel. To grind on
the side of the wheel could cause wear and
weaken the wheel.
HEAD OF
TROUGH
DRILL CLAMP SCREW
DRILL CLAMP
TROUGH
ANGLE ADJUSTING NUT
FEED NUT
LIP
STOP
PIVOT PIN
TENSION SCREW
ADJUSTING SIDE BRACKET
SLOTTED BASE
IMPORTANT: ALWAYS WEAR SAFETY
GLASSES WHEN USING OR IN WORK AREA.
DRAPER TOOLS LIMITED,
HURSLEY ROAD, CHANDLER'S FORD,
EASTLEIGH, HANTS. SO53 1YF. ENGLAND.
TEL: (01703) 266355.
Page 1
DRILL GRINDING
ATTACHMENT
STOCK No.10751
• INSTRUCTIONS •
FEED SCREW
IMPORTANT: PLEASE READ THESE
LOCKING
INSTRUCTIONS CAREFULLY TO
NUT
ENSURE THE SAFE AND EFFECTIVE
USE OF THIS TOOL.
09/98
PART No.1180
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Draper 1180
Summary of Contents for Draper 1180
- Page 1 HEAD OF TROUGH DRILL CLAMP SCREW DRILL GRINDING ATTACHMENT DRILL CLAMP TROUGH STOCK No.10751 PART No.1180 ANGLE ADJUSTING NUT FEED NUT • INSTRUCTIONS • STOP FEED SCREW IMPORTANT: PLEASE READ THESE LOCKING INSTRUCTIONS CAREFULLY TO ENSURE THE SAFE AND EFFECTIVE USE OF THIS TOOL.
- Page 2 10751 Instructions 12/2/02 5:20 PM Page 3 FIG.2 FIG.3 HEAD OF FIG.1 TROUGH DRILL OVERHANG STOP DIMENSION CUTTING LIP RELIEF ANGLE LIP ANGLE 8˚ TO 12˚ To produce the best results, the attachment must be should now be adjusted to produce the overhang situated in the right position in conjunction with your required.
- Page 3 HEAD OF TROUGH DRILL CLAMP SCREW DRILL GRINDING ATTACHMENT DRILL CLAMP TROUGH STOCK No.10751 PART No.1180 ANGLE ADJUSTING NUT FEED NUT • INSTRUCTIONS • STOP FEED SCREW IMPORTANT: PLEASE READ THESE LOCKING INSTRUCTIONS CAREFULLY TO ENSURE THE SAFE AND EFFECTIVE USE OF THIS TOOL.
Need help?
Do you have a question about the 1180 and is the answer not in the manual?
Questions and answers