Advertisement
Table of Contents
Home
Products
About GRI
UL Listed Pool Alarms
Part Numbers
The GRI DPA-10 Series Pool Alarms operate on a 9 volt battery. U.L. requires that a Duracell
alkaline battery Model MN1604 be used. Both units will operate at any voltage of 5-15 volts
maximum. 12 volts is recommended to prevent sounder volume from dropping below minimum
sound pressure levels of 85dB at 10'.
Contact GRI
Where to Buy
Monitors Entry to Pool/Spa Areas
Listed per U.L. 2017
Microprocessor Controlled
Battery Operated
Low Battery Indicator
Exceeds Operational Requirements of Model Barrier Codes
Surface Mount
DPA-10 Instant On
DPA-10D 7 Second Delay
Testimonials
What's New!
Advertisement
Table of Contents
Related Manuals for GRI DPA-10
Summary of Contents for GRI DPA-10
- Page 1 DPA-10 Instant On DPA-10D 7 Second Delay The GRI DPA-10 Series Pool Alarms operate on a 9 volt battery. U.L. requires that a Duracell alkaline battery Model MN1604 be used. Both units will operate at any voltage of 5-15 volts maximum.
-
Page 2: Closed Loop
The GRI DPA-10 uses a microprocessor to monitor the CLOSED LOOP magnetic reed switch(es), shunt/cancel button, and battery voltage and provides the timing options. Model DPA-10 is set to alarm instantly if the protected door is opened before pressing the shunt/cancel button. Model DPA-10D is set to an initial seven second delay. In which case, the unit will wait 7 seconds upon door opening before alarming. -
Page 3: Installation
The alarm will beep once during power up indicating a successful diag- nostics test. Lay the battery in the bottom of the case and reassemble the DPA-10 with the button toward the bottom of the case and the sounder above. Secure with the two screws provided. -
Page 4: Installation & Wiring
9 Volt Alkaline Duracell automatically reset upon expiration. Model MN1604 The GRI POOL ALARM operates on a 9 volt battery. It is required that Typical Battery Life Approximately 3 to 6 months a Duracell alkaline battery Model MN1604 be used. - Page 5 TION INSTRUCTIONS Maximum 36” To Screen Door SW. A) Installing the Door Sensor The GRI POOL ALARM uses CLOSED LOOP magnetic reed switches. The POOL ALARM must be mounted as per local codes and/or regulations. Please confirm Alarm To Alarm location prior to locating and mounting door sensor.
Need help?
Do you have a question about the DPA-10 and is the answer not in the manual?
Questions and answers