GRI 289-1 Product Description

TM1
JP1
1
2
Figure 2.
3
4
Terminal
5
Connections 6
7
& Jumpers
JP1
X
X
X
It is suggested that some type of surge protection, such as the GRI CS-1
Current Sensor, be used between the power supply and all GRI Pool Alarms
using external power.
NOTE: Unit will function at minimum 5VDC at a very limited sounder vol-
ume. This power level is considered total battery failure.

SPECIFICATIONS:

Battery Type
Battery Life
External Power Supply
Low Bat Mode
Mounting Height
Sounder Rated
Switch
WARRANTY: One year against workmanship, material and factory defects.
DISCLAIMER
The G.R.I. Door Alert/Pool Alarm is not a life saving device. Its' intent
is to serve strictly as a monitoring device on doors and windows to
help prevent unattended access to pool and spa areas.
5/23/2007
TERMINAL TM1 TERMINAL TM1 TERMINAL TM1 TERMINAL TM1 TERMINAL TM1 PIN PIN PIN PIN PIN
External Power (+) 1
Ground 2
Door
Remote Sounder Controller 3
Contact
Remote Reset/Delay Switch 4
Connections
Door Contact 5
Remote Sounder Power (+) 6
Alarm Signal 7
The jumpers on JP1 are factory
preselected. Alteration can effect tim-
ing and/or delay function.
Battery Clip
Recommended
alkaline battery
Standard 9 Volt
Approximately 2 weeks
12V DC 500 mA Output
Applied Voltage must not exceed
15 Volts DC
7V DC
Ref. Local Code
85 dB at 10 Ft. (3.5 M)
Closed Loop
PRODUCT DESCRIPTION FOR THE
DOOR ALERT/POOL ALARM
Models 289-1, 289-2, 289-3 and 289-4
Type SM Signaling Device
ETL Tested To Be In Compliance With Standard For Safety,
UL 2017, and Florida Building Commission Code Requirements,
Per ETL Listing Number 3035022

APPLICATION:

The GRI DOOR ALERT/POOL ALARM is designed as an aid to detect
unsupervised access to a pool/spa area by a small child. Monitoring all
doors and windows with magnetic reed switches the DOOR ALERT/POOL
ALARM will sound an alarm should anyone too small to manage the adult
pass through feature attempt access to the pool/spa area. For maximum
protection all moveable openings should be protected in such a manner
by the GRI DOOR ALERT/POOL ALARM.

DESCRIPTION:

The GRI DOOR ALERT/POOL ALARM uses a microprocessor to monitor
the CLOSED LOOP magnetic reed switches, shunt/cancel button, battery
and power supply voltages, and to provide the timing options. The re-
cessed versions are designed to fit inside a single gang utility box, while
the surface mount versions may easily be mounted to the wall of any
structure.
The 289-1 and 289-2 versions offer a seven second delay in which an
adult may open the protected door, shut it, and then press the shunt/
cancel button without the alarm sounding.
The 289-3 and 289-4 versions alarm instantly if the protected door is open
before the shunt/cancel button is pressed.
All versions must be operated with a 12 volt externally supplied DC power
source. An onboard 9 volt battery can be used, in which case the battery
will perform a backup function should the externally supplied source fail
for any reason. The GRI DOOR ALERT/POOL ALARM is designed to
maintain a minimum sound pressure level.
MODEL NUMBER AND VERSION
289-1 Recessed Door Alert/Pool Alarm 7 Second Delay
289-2 Surface Mount Door Alert/Pool Alarm 7 Second Delay
289-3 Recessed Door Alert/Pool Alarm Instant On
289-4 Surface Mount Door Alert/Pool Alarm Instant On