GRI GT10 Quick Start Manual

GRI GT10 Quick Start Manual

Gate mount pool alarm

Advertisement

Gate Mount
Pool Alarm
Microprocessor controlled
Weather resistant for outdoor use
Instant on or 7 sec. delay models available
Low Battery Indicator
Closed Loop 410P switch set
with 5 ft. 2 conductor cable
The GRI Gate Mount Pool Alarm was designed as an
aid for prevention of an unattended access to a pool/
spa area by a small child. Monitoring all gates with Closed
Loop magnetic reed switches, the Gate Mount Pool Alarm
will sound an alarm should anyone too small to manage the
adult pass through feature attempt access to the pool/spa area. For maximum protection all movable
openings should be protected in such a manner by the GRI Gate Mount Pool Alarm.
The GT10-2 and GT10-4 can be operated independently with an on-board 9 volt battery or with a 12 volt
externally supplied DC power source. Both power sources have been designed to maintain a maximum
sound pressure level of 85db at 10' . Estimated battery life is approximately 180 days based on no alarm
soundings during that time lapse. Should the battery voltage drop below 7 volts, a low battery mode
will be initiated and the unit will sound 3 beeps approximately every 30 minutes for one to two weeks
prior to total battery failure. Battery must be replaced at this time, and the cuase of the power failure
determined and restored.
NOTE: Unit will function at a minimum 5VDC at a very limited sounder volume. This power level is considered
total battery failure.
CLEANING: Periodic cleaning of sounder and box are required to maintain sound level.
CAUTION: To prevent a memory failure or circuit damage, external power source not to exceed 15VDC.
WARNING: Environmental conditions, such as wind, may affect the sound level.
GT10-2
GT10-4

WARRANTY:

One year warranty against workmanship, material and factory defects.
GEORGE RISK INDUSTRIES, INC.
G.R.I. PLAZA
KIMBALL, NE 69145
WWW.GRISK.COM
WWW.GRISK.COM
GT10
Closed Loop
WARNING: THIS IS NOT A LIFE SAVING DEVICE.

Part Numbers

Gate Mount Pool Alarm - 7 Second Delay - Closed Loop
Gate Mount Pool Alarm - Instant On - Closed Loop
C_PA 5 Gate Mount Pool Alarm GT-10
Made in U.S.A.
TOLL-FREE 1-800-445-5218
TOLL-FREE 1-800-523-1227
(308) 235-4645
FAX (308) 235-3561
E-MAIL: sales@grisk.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GT10 and is the answer not in the manual?

Questions and answers

Summary of Contents for GRI GT10

  • Page 1 GRI Gate Mount Pool Alarm. The GT10-2 and GT10-4 can be operated independently with an on-board 9 volt battery or with a 12 volt externally supplied DC power source. Both power sources have been designed to maintain a maximum sound pressure level of 85db at 10’...
  • Page 2 Drain hole location INSTALLATION INSTRUCTIONS: The GRI Gate Mount Pool Access Alarm mounts easily to the fence by any gate which allows access to the pool/spa area. Using a Closed Loop magnetic reed switch, the unit will detect and announce an open access by sounding a loud continuous alarm.

This manual is also suitable for:

Gt10-2Gt10-4

Table of Contents