Related Manuals for Clarke Power CP6550NESLR
Summary of Contents for Clarke Power CP6550NESLR
- Page 1 GENERATOR MODEL NO: CP6550NESLR PART NO: 8857685 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC01/25-REV 1...
-
Page 2: Environmental Protection
INTRODUCTION Thank you for purchasing this CLARKE Generator. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: General Safety Rules
GENERAL SAFETY RULES WARNING: EXHAUST FUMES CAN BE EXTREMELY DANGEROUS IF INHALED WORK AREA 1. ALWAYS use in a well ventilated area. 2. ALWAYS position the exhaust outlet away from people. 3. Read these safety instructions before using the equipment. 4. -
Page 4: Exhaust Gas Precautions
13. DO NOT Alter the engine settings, the voltage and frequency of the generator output is directly linked to the engine speed. These settings are factory set. Should they need re-calibration - consult your CLARKE dealer. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 5: Safety Symbols
14. Connect only those appliances whose voltage (according to their data plate) corresponds to that produced by the generator. IMPORTANT!: This generator uses a floating chassis (refer to technical information sheet). Floating earth generators DO NOT require earthing. SAFETY SYMBOLS The following safety symbols are shown on the product or it’s packaging. -
Page 6: Unpacking And Assembly
UNPACKING AND ASSEMBLY Unpack your generator and check all are present. Should there be any missing or damaged during transit contact your CLARKE dealer. BEFORE USING THE GENERATOR Before using your generator check that the generator is: • In good condition and free from any damage. - Page 7 • DO NOT tilt the generator when adding engine oil. This could result in overfilling and damage to the engine. 5. Replace and tighten the oil filler cap. ADDING/CHECKING THE FUEL LEVEL WARNING: MAKE SURE THERE IS FUEL IN THE TANK WHEN USING THE GENERATOR.
- Page 8 4. Replace the fuel filler cap securely. NOTE: Long range ‘LR’ models are fitted with a three position fuel tap as illustrated in fig.1. These positions are ON/OFF/ RESERVE. • Ensure the tap is set in the required position. • The fuel hose connectors are intact and there is no leakage.
-
Page 9: Preparation For Use
The battery must be prepared as follows: Check to ensure the battery is in good condition, with no damage caused during transit. Should there be any apparent damage, please consult your CLARKE dealer immediately. 1. Disconnect and remove the battery from the frame. -
Page 10: Extension Cables
EXTENSION CABLES All extension cables, from the generator set to the appliance, must be carefully selected, fitted and maintained. Cables in accordance with IEC 245-4 should be used. Cables should be inspected regularly, and should be replaced, not repaired in the event of a defect. - Page 11 Some appliances draw more current on start-up than their normal running current, i.e. electric motors, and compressors. If in any doubt as to whether an appliance is compatible or not, please consult your CLARKE dealer. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
-
Page 12: Shutting Down The Generator
3. Fill the oil reservoir with fresh oil. • DO NOT fill above the max level mark. • We recommend the use of SAE10W/30 oil in this generator. (CLARKE part number 3050845) 4. Replace the oil filler cap. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... - Page 13 2. Remove the air filter panel and the air filter element. 3. If the air filter is damaged contact the CLARKE spare parts department for a replacement. • If the filter is dirty, wash it in a solution of warm water and mild detergent and then rinse thoroughly.
- Page 14 1. Remove the fuel tank cap. 2. Lift out the filter inside. 3. Clean the filter with solvent. If the filter is damaged, contact CLARKE Spare Parts department for a replacement. 4. Replace the filter and fuel tank cap.
-
Page 15: Troubleshooting
Erratic supply Incorrect engine rpm Adjust the engine speed Internal alternator problem Contact CLARKE servicing If this does not solve your problem, please contact the CLARKE service department. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 16: Schematic Wiring Diagram
SCHEMATIC WIRING DIAGRAM Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 17: Spare Parts
SPARE PARTS Frame SH0211009 Alternator mount SH0270004 Engine mount SH0270027 Alternator NAC5500 BC-A0/T SH0130090 IP23 Alternator cover SH0280040 Control box D/V wired cw covers SH0491001 Control box 5 SKT CON5 SH0090193 Mounting set C/BOX SH0130106 Collar SH0130063 Grommet SH0130070 MCB GTEC 25AMP 1 pole SH0360011 MCB GTEC 50AMP 1 pole SH0360020... -
Page 18: Specification
SPECIFICATION Item Specification Model No CP6550NESLR Dimensions (L x W x H) 710 x 510 x 600 mm Weight 87 kg Engine type Honda GX390 Displacement 389cc Engine power 13HP Fuel capacity 15.5 L Fuel consumption 2.16 L/h Running time (full tank) 7.2 H Fuel type Unleaded... -
Page 19: Declarations Of Conformity
DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the Power CP6550NESLR and is the answer not in the manual?
Questions and answers