Clarke CP Range Operating & Maintenance Instructions
Clarke CP Range Operating & Maintenance Instructions

Clarke CP Range Operating & Maintenance Instructions

Generator set

Advertisement

Quick Links

Generator Set
CP Range
Operating & Maintenance
Instructions
©
0702

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CP Range and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Clarke CP Range

  • Page 1 Generator Set CP Range Operating & Maintenance Instructions © 0702...
  • Page 2: Table Of Contents

    Read these safety instructions before using the equipment. Introduction Thank you for purchasing this Clarke portable Generator set. The set is powered by a Honda engine, a manual for which, is provided separately. Please refer to that manual for all matters relating to the engine, ...starting and stopping procedures,...
  • Page 3: Important General Notes

    DO NOT alter the engine settings..the voltage and frequency of the generator output is directly linked to the engine speed. These settings are set at the factory. Should they need recalibration - consult your Clarke dealer • Connect ONLY those apppliances whose voltage, according to its data plate, corresponds to that produced by the generator set.
  • Page 4 Fire Prevention Always switch the engine OFF when refuelling. Always refuel away from any source of heat. Always refuel in a well ventilated area. Never overfill the tank, fill to the level specified. Never smoke whilst refuelling and avoid smoking or using a naked flame near the generator.
  • Page 5: Preparation For Use

    The battery must be prepared as follows: Check to ensure the battery is in good condition, with no damage caused during transit. Should there be any apparent damage, pleasse contact your Clarke dealer immediately. Disconnect the leads and remove the battery from the frame.
  • Page 6: Extension Cables

    Fig.1 WARNING ! • Observe all safety precautions when handling fuel. Always refuel in a well ventilated area away from any heat sources. • Ensure there is adequate fuel in the tank when using the generator. Running out of fuel or stopping the engine suddenly with a load connected could cause serious damage.
  • Page 7: Using Your Generator

    Some appliances draw more current on startup than their nominal running current ..electric motors and compressors are examples. If in doubt as to whether an appliance is compatible or not, please contact your nearest Clarke dealer. Additionally, please refer to the ‘Specifications’ sheet attached, to ensure the machine is used under the correct operating conditions.
  • Page 8: Shutting Down The Generator

    2. Reset AC safety trip Tripped Circuit Breaker 3. Check connection and Poor connection or faulty (or) replace lead lead 4. Contact Clarke Servicing Broken AC connector 5. Contact Clarke Servicing Faulty Circuit Breaker 1. Set Engine RPM - Consult Incorrect engine RPM...

This manual is also suitable for:

Power cp series

Table of Contents