Clarke CP range User Instructions
  1. Manuals
  2. Brands
  3. Clarke Manuals
  4. Portable Generator
  5. CP range
  6. User instructions
Clarke CP range User Instructions

Clarke CP range User Instructions

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
GENERATOR SET
GENERATOR SET
CP/CYB/CD Range
USER INSTRUCTIONS
0706

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CP range and is the answer not in the manual?

Questions and answers

Related Manuals for Clarke CP range

Summary of Contents for Clarke CP range

  • Page 1 GENERATOR SET GENERATOR SET CP/CYB/CD Range USER INSTRUCTIONS 0706...

  • Page 2: Table Of Contents

    Please Note that details and specifications herein, are correct of time of going to print. However CLARKE International reserve the right to change specifications at any time without prior notice. Copyright CLARKE International All rights Reserved 2006. - 1 -...

  • Page 3: Important Safety Precautions

    DO NOT Alter the engine settings, the voltage and frequency of the generator output is directly linked to the engine speed. These settings are factory set. Should they need re-calibration - consult your CLARKE dealer. • Connect only those appliances whose voltage (according to their data plate) corresponds to that produced by the generator.
  • Page 4 FIRE PREVENTION • ALWAYS switch the engine OFF when refuelling. • ALWAYS refuel away from any source of heat. • ALWAYS refuel in a well ventilated area. • NEVER overfill fill the tank, fill to the level specified. • NEVER smoke whilst refuelling and avoid smoking or using a naked flame near the generator.

  • Page 5: Preparation For Use

    Check to ensure the battery is in good condition, with no damage caused during transit. Should there be any apparent damage, please consult your CLARKE dealer immediately. Disconnect the and remove the battery from the frame. Remove the vent plugs and fill to 12mm above the top of the separators.

  • Page 6: Extension Cables

    Fig.1 WARNING: • Observe all safety precautions when handling fuel. Always refuel in a well ventilated area away from any heat sources. • Ensure there is adequate fuel in the tank when using the generator. Running out of fuel or stopping the engine suddenly with a load connected could cause serious damage.

  • Page 7: Operation

    Some appliances draw more current on start-up than their normal running current, i.e. electric motors, and compressors. If in any doubt as to whether an appliance is compatible or not, please consult your CLARKE dealer. Additionally, please refer to the specifications sheet attached, to ensure the machine is used under the correct operating conditions.

  • Page 8: Shutting Down The Generator

    Broken AC connector. Contact CLARKE servicing. Faulty circuit breaker. Contact CLARKE servicing. PROBLEM: Erratic Supply. CAUSE: TROUBLE SHOOTING: Set engine RPM - Consult your CLARKE Incorrect engine RPM. dealer. Internal alternator problem. Contact CLARKE servicing. ENGINE TROUBLE SHOOTING Consult the engine manual.

This manual is also suitable for:

Cyb rangeCd rangePower cp seriesPower cyb seriesPower cd series

Table of Contents