Britax ROUNDABOUT 50 CLASSIC User Manual page 23

4 Verify that the vehicle belt is not twisted and
then buckle (Fig. D).
5 Push the child seat firmly into the vehicle seat
while removing slack from the vehicle belt.
• Ensure the vehicle seat belt system is locked.
WARNING!
with a two-point Emergency Locking Retractor
(ELR) vehicle belt that does not lock.
6 Verify that the vehicle belt is tight, locked,
and that the child seat is secure.
• The child seat is secure when it cannot be
moved more than one inch (2.5 cm) front-to-
back or side-to-side at the belt path.
• When properly installed in the rear-facing
position, the back angle of the child seat
should be 30º – 45º from vertical (not to
exceed 45º) when the car is parked on a level
surface (Fig. F).
• If necessary, the proper recline angle can be
achieved by placing a rolled towel or pool noodle
in the crease of the vehicle seat to level the child
seat's base.
WARNING!
seat off the front edge of the vehicle seat.
This could cause your child seat not to
perform as intended.
• Rear-facing installation can be improved by the use of the Versa-Tether.
See pages 29 - 32.
Do not use this seat
Do not raise the child
Installation: Rear-Facing
D
F
21