Lap-Shoulder Belt Installation - Britax ROUNDABOUT 50 CLASSIC User Manual

Installation: Rear-Facing

Lap-Shoulder Belt Installation

• Figure A illustrates a typical rear-facing, lap-
shoulder belt installation.
• When not in use, always store the LATCH
connectors in the storage slots.
See page 34.
• See vehicle owner's manual to determine what
type of seat belt system your vehicle has, and
how to lock it (also see pg 10-13).
IMPORTANT: This child seat is shipped with the
buckle in position 1 (Fig. B). Use buckle position
1 or 2 that is closest to but not underneath your
child. Do not use buckle position 3 in rear-facing
mode. See page 38 for Adjusting Harness Buckle
Position.
1 Recline the child seat then place it rear-facing
on the vehicle seat.
the recline position when installed rear-facing.
See Recline Adjustment on page 34.
2 Pull the vehicle belt out then pass it through
the first rear-facing belt slot (Fig. C).
3 Route the vehicle belt across the child
seat and then through the second rear-
facing belt slot.
IMPORTANT:
• The vehicle belt must rest IN FRONT OF the
child seat buckle when using buckle slots 1
or 2 (Fig. B).
• Vehicle belt can be routed over or under the
cover.
4 Verify that the vehicle belt is not twisted and
then buckle (Fig. D).
5 Push the child seat firmly into the vehicle seat
while removing slack first from the lap portion
of the vehicle belt, then the shoulder portion
(Fig. E).
18
This child seat must be in
A
b
C
D