Britax ROUNDABOUT 50 CLASSIC User Manual page 21

• Ensure the vehicle seat belt system is locked.
• If your vehicle is not equipped with a lockable
seat belt system, use of a locking clip may
be required. See page 35 for locking clip
instructions
6 Verify that the vehicle belt is tight, locked and
that the child seat is secure.
• The child seat is secure when it cannot be
moved more than 1 in. (2.5 cm) front-to-back or
side-to-side at the belt path.
• When properly installed in the rear-facing position,
the back angle of the child seat should be 30º –
45º from vertical (not to exceed 45º) when the car
is parked on a level surface (Fig. F).
• If necessary, the proper recline angle can be
achieved by placing a rolled towel or pool
noodle in the vehicle seat bight to level the child
seat's base.
WARNING!
seat off the front edge of the vehicle seat.
This could cause your child seat not to
perform as intended.
• Rear-facing installation can be improved by using the Versa-Tether. See
pages 29 - 32.
Do not raise the child
Installation: Rear-Facing
E
F
19