Lap-Shoulder Belt Installation - Britax ROUNDABOUT 50 CLASSIC User Manual

Installation: Forward-Facing

Lap-Shoulder Belt Installation

• Figure A illustrates a typical forward-facing lap-
shoulder belt installation.
• When not in use, always store LATCH connectors
in storage slots. See page 34.
• See vehicle owner's manual to determine what
type of seat belt system your vehicle has, and
how to lock it.
WARNING!
• This child seat must not be used forward-
facing for children less than one year of age
OR who weigh less than 20 lbs (9.1 kg).
• Child seat must be in the full upright
position when installed in forward-facing
mode with children over 33 lbs (15.1 kg).
IMPORTANT:
• The child seat is shipped with the buckle in position 1 (Fig. B). Use buckle
position 1, 2 or 3 that is closest to but not underneath your child. See
page 38 for Adjusting Harness Buckle Position.
• Britax recommends that the Versa-Tether be used at all times. Using the
tether will improve the stability of the child seat and reduce the risk of
injury. Check your vehicle owner's manual for approved tether anchor
locations.
1 If the vehicle is equipped with an approved tether anchor for the
chosen seating position, remove the Versa-Tether
and place it up and over the child seat back.
2 Place the child seat forward-facing on the vehicle seat.
You may need to raise or remove the vehicle head restraint to
TIP:
achieve best fit of the child seat.
24
A
b
from the pouch
®