Removing The Infant Carrier - Britax CHAPERONE User Manual

46 Installing Your Infant Carrier without Base
Follow the steps below if adjustment of the recline angle is
necessary:
a
Unbuckle the seat belt.
b
Place a rolled towel or pool
noodle(s) in the vehicle seat
bight.
* See note below.
Repeat the previous steps until a secure installation with proper
recline angle is achieved. Continue with installation instructions from
step 2 on page 44.
NOTE: Configure pool noodle(s) to accommodate variations in
vehicle seat contour as necessary.

Removing the Infant Carrier

1 Unbuckle the vehicle belt.
Pull the vehicle belt from the infant carrier belt guides.
2
IMPORTANT: If you have installed the infant carrier using a locking clip,
ensure that the locking clip is removed before the vehicle belt is used
by a passenger not riding in a child restraint.
c
Place the infant carrier on the
towel or pool noodle(s) to help
level the base.