Maintenance - Evolution R180IDR-Li Original Instructions Manual

EN INTENDED USE OF THIS POWER TOOL
This product is an impact driver and is used for fastening
and removing screws and bolts.
PLEASE READ THE GENERAL POWER TOOL SAFETY
BOOKLET PROVIDED SEPARATELY BEFORE USING
THIS TOOL.
ADDITIONAL SAFETY INSTRUCTIONS FOR
IMPACT DRIVERS
• Hold the power tool by insulated gripping surfaces,
when performing an operation where the fastener may
contact hidden wiring. Fasteners contacting a "live" wire
may make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
RESIDUAL RISKS
Even with application of safety standards and using the
tool as prescribed, certain residual risks can remain:
• Risk of personal injury due to prolonged use.
• Risk of injury caused by dust.
• Risk of injury caused by flying objects.
• Risk of burns due to accessories becoming hot.
STORAGE
• Store the device and its accessories in a dry and
dustproof location. Store it out of the reach of
children.
• Store the bits separately to avoid mechanical damage
or confusion with other tools. Protect the bits from
excessive heat (e.g. by storing near heating pipes or
steam pipes) and from UV radiation.
• If you intend to store a battery for a period without
use then store battery at room temperature (0°C
to 20°C) When storing for very long periods boost
charge the battery once per year to prevent over
discharge. The Ambient temperature range for
tool and battery use: 0°C to 40°C. The charging
temperature: 5°C to 40°C.
CLEANING
• The device must not be sprayed with water or placed
in water. Otherwise there is a risk of electric shock.
• Keep the device, its handle and the accessories clean.
Use a dry cloth or brush to do this. Do not use any
cleaning agents or solvents. They could damage the
device irreparably. Do not use water or metal objects.

MAINTENANCE

If a fault develops, disconnect the battery immediately and
contact Evolution Power Tools Customer Service. Do not
attempt to repair the tool.
PRODUCT OVERVIEW KEY
1. LED lights x3
2. 1/4" chuck
3. Rotation direction switch
4. ON/OFF variable trigger
5. Ergonomic handle
6. Battery port
7. Belt hook
8. Belt hook screw
NOISE WARNING
WARNING: The noise emissions during actual use
of the power tool can differ from the declared values
depending on the ways in which the tool is used
especially what kind of workpiece is processed.
ADDITIONAL BATTERY AND CHARGER
SAFETY WARNINGS
Please refer to the safety warnings and instructions
provided in the battery manual and the charger manual.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for
recycling advice.