Saxby Lighting Equinox 119098 Instruction Manual

Fitting / replacing bulb
When changing a bulb, always switch off at the mains and allow the bulb to cool before handling. Dispose of used bulbs carefully.
Do not exceed the wattage stated or use a different shape bulb from that indicated on the fitting.
To access the bulb, simply unscrew the shade.
Unscrew the old bulb from the lampholder and replace with a new one.
Then screw the shade back in place.
Technical data
Supply
220-240V~, 50Hz
Voltage:
Bulb
1 x Max. 8W LED E27 stick (required)
Type:
Conformity with all relevant UKCA Directive requirements.
Conformity with all relevant EC Directive requirements.
This is a Class 1 product and must be earthed.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
This product is rated at IP44
44
IP
Care and Safety
Allow 10 minutes to cool before replacing, adjusting or cleaning.
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before changing lightbulbs, or cleaning.
In normal circumstances, stainless steel is very resistant to corrosion. It does however require maintenance to preserve the
high quality appearance. Wash the product with warm soapy water, removing all surface deposits. Rinse with clear water and
with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after installation. This is normally caused by tiny iron particles left behind after
the brushing process when finishing.
Wash and dry as detailed above. Then with a soft cloth soaked with a protective oil, wipe all over. However if the product is
subject to extreme environmental conditions such as marine locations, industrial pollution and acid rain these maintenance
procedures should be carried out around four times a year. For severe corrosion, non-abrasive cream cleaners or proprietary
stainless steel cleaners should be used to remove the corrosion. Wash and dry as detailed above. Then with a soft cloth soaked
with a protective oil, wipe all over.
Do not clean the units with a pressure washer.
The bulb source is protected by the shade. The shade must be replaced immediately should it
become cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked Shade
V8 19/03/2025
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
Instruction manual
Equinox
Max. 8W LED E27
119098, 49911, 49910
www.saxbylighting.com
119098 49911 49910