Saxby Lighting Avit CCT Instruction Manual

Wiring
Having correctly identified the wiring from your existing light fitting, pull the mains wire through the hole and connect to the
quick fit connection block inside the product in the following way:
SUPPLY
INSERT CABLE
SWITCHED LIVE
NEUTRAL
Technical data
Supply
220-240 V~, 50 Hz
Voltage:
Bulb
10W LED module CCT, 3000K/4000K/6000K This product contains a light source of energy efficiency class D.
Type:
Replaceable (LED only) light
source by a professional
Conformity with all relevant UKCA
Directive requirements.
The power supply is Double Insulated
and does not require connection to an
Earth circuit.
This product is not suitable for dimming.
Care and Safety
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before cleaning.
This light source is protected by a shade. This part must be replaced immediately should the shade
become cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked Shade
For further information, please visit https://www.lighting-info.co.uk/113565
V1 26/09/2024
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
PUSH DOWN
LIGHT FITTING
Check that...
• You have correctly identified
the wires.
BROWN (L)
• The connections are tight.
• No loose strands have been
BLUE (N)
left out of the connection block.
Replaceable control gear by a
professional
Conformity with all relevant EC
Directive requirements.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or local store for recycling advice.
This product is rated at IP65.
65
IP
Instruction manual
Avit CCT
113565
www.saxbylighting.com