Digi IX15 User Manual page 623

Services
Configure geofencing
Geofencing is a mechanism to create a virtual perimeter that allows you configure your IX15 device
to perform actions when entering or exiting the perimeter. For example, you can configure a device
to factory default if its location service indicates that it has been moved outside of the geofence.
Multiple geofences can be defined for one device, allowing for a complex configuration in which
different actions are taken depending on the physical location of the device.
Required configuration items
Location services must be enabled.
n
The geofence must be enabled.
n
The boundary type of the geofence, either circular or polygonal.
n
If boundary type is circular, the latitude and longitude of the center point of the circle,
l
and the radius.
If boundary type is polygonal, the latitude and longitude of the polygon's vertices (a
l
vertex is the point at which two sides of a polygon meet). Three vertices will create a
triangular polygon; four will create a square, etc. Complex polygons can be defined.
Actions that will be taken when the device's location triggers a geofence event. You can
n
define actions for two types of events:
Actions taken when the device enters the boundary of the geofence, or is inside the
l
boundary when the device boots.
Actions taken when the device exits the boundary of the geofence, or is outside the
l
boundary when the device boots.
For each event type:
Determine if the action(s) associated with the event type should be performed when the
l
device boots inside or outside of the geofence boundary.
The number of update intervals that should take place before the action(s) are taken.
l
Multiple actions can be configured for each type of event. For each action:
The type of action, either a factory erase or executing a custom script.
l
If a custom script is used:
l
o The script that will be executed.
o Whether to log output and errors from the script.
o The maximum memory that the script will have available.
o Whether the script should be executed within a sandbox that will prevent the script
from affecting the system itself.
Additional configuration items
n Update interval, which determines the amount of time that the geofence should wait
between polling for updated location data.
É
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
Digi IX15 Gateway User Guide
Location information
623