I/O Ports; Installing Memory - Supero 6025B-8R Plus User Manual

5-4

I/O Ports

The I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-4 below for the colors and locations of the various I/O ports.
5-5

Installing Memory

Note: Check the Supermicro web site for recommended memory modules.
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage. Also note that the memory is inter-
leaved to improve performance (see step 1).
DIMM Installation (See Figure 5-5)
1. Insert the desired number of DIMMs into the memory slots, starting with DIMM
1A. The memory scheme is interleaved so you must install two modules at a time,
beginning with DIMM 1A and DIMM 2A and so on. (See the Memory Installation
Table below.) Insert each DIMM module vertically into its slot. Pay attention to
the notch along the bottom of the module to prevent inserting the DIMM module
incorrectly.
2. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules (see step 1 above).
Chapter 5: Advanced Serverboard Setup
Figure 5-4. Rear Panel I/O Ports
CAUTION!
5-7