System Power Force On; Vga Enable/Disable; Scsi Controller Enable/Disable; Scsi Termination Enable/Disable - Supero SUPERSERVER 5025M-4+ User Manual

System Power Force On

Jumper JPF allows you to enable or
disable the Force-Power-On function.
If enabled, system power will always
stay on. If disabled (the normal set-
ting), the user needs to press the power
button to power on the system.

VGA Enable/Disable

JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
SCSI Controller Enable/
Disable (5025M-4+ only)
Jumper JPA1 is used to enable or dis-
able the LSI SCSI controller. The de-
fault setting is on pins 1-2 to enable
SCSI. See the table on the right for
jumper settings.
SCSI Termination Enable/
Disable (5025M-4+ only)
Jumper JPA2 is used to enable or dis-
able termination for the SCSI connec-
tor. The default setting is open to en-
able termination. See the table on the
right for jumper settings.
Note: In order for the SCSI drives to
function properly, please do not change
the default setting (enabled) set by the
manufacturer.)
Chapter 5: Advanced Motherboard Setup
System Power Force On
Jumper Settings
Jumper Setting
Closed
Open
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
SCSI Enable/Disable
Jumper Settings (JPA1)
Both Jumpers
Pins 1-2
Pins 2-3
SCSI Term. Enable/Disable
Jumper Settings (JPA2)
Jumper Setting
Open
Closed
5-19
(JPF)
Defi nition
Force On
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled