Advertisement

PLUNGE ROUTER
6.35mm
MODEL NO. PRG-632VK
OPERATING INSTRUCTIONS
0208
Always Wear Eye, Face & Ear Protection
www.ozito.com.au

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRG-632VK and is the answer not in the manual?

Questions and answers

Summary of Contents for Ozito PRG-632VK

  • Page 1 PLUNGE ROUTER 6.35mm MODEL NO. PRG-632VK OPERATING INSTRUCTIONS 0208 Always Wear Eye, Face & Ear Protection www.ozito.com.au...
  • Page 2 SPECIFICATIONS - MODEL NO. MSH-115 SPECIFICATIONS - MODEL NO. PRG-632VK Motor size: 1200W Input: 230V ~ 50Hz No load speed: 16,000 – 34,000 rpm Collet size: 6.35mm ( ”) Plunge depth: 42mm Features: Variable speed Spindle lock Lock off switch 12 TCT router bits included 1.
  • Page 3: Safety Instructions

    We aim to provide quality tools at an affordable price. We hope you will enjoy using this tool for many years. Your Ozito Plunge Router PRG-632VK has been designed for routing wood and wood products and is intended for DIY use only.
  • Page 4 GENERAL 1. Keep work areas clean. Cluttered work areas and benches can cause accidents. 2. Consider work area environment. Do not expose your tool to high humidity or rain. Do not use your tool in damp or wet conditions. Keep the work area well lit.
  • Page 5 GENERAL (cont.) 13. Check for damaged parts. Before use carefully check the tool and power lead for damage. Check for misalignment and seizure of moving parts, breakage of parts, damage to guards and switches and any other conditions that may affect its operation.
  • Page 6: Additional Safety Instructions For Routers

    ADDITIONAL SAFETY INSTRUCTIONS FOR ROUTERS • Wear safety glasses or goggles when operating this tool. • Only use router bits with a shank diameter equal to the size of the collet installed in the tool. • Only use router bits suitable for the no-load speed of the tool. •...
  • Page 7 ASSEMBLY (cont.) Fitting the Straight Guide Fence The straight guide fence helps to guide the tool parallel to the edge of the work piece. • Remove the screws and washers from the ends of the fence bars. Place the bar ends to the corresponding holes in the fence, as shown on page 2.
  • Page 8: Operation

    OPERATION Adjusting the Depth of Cut The depth of cut is the distance X between the depth rod (2) and the 8 tier depth stop (13). The depth of cut can be set in two different ways as described below. Adjusting the Depth of Cut using a Piece of Wood •...
  • Page 9 OPERATION (cont.) • Select the desired speed on the variable dial. • Switch the router on with your right hand. • Use your left hand to guide the plunge down steadily. • Make the desired cut, using your right hand to guide the router motion across the surface of the work piece.
  • Page 10: Maintenance

    Always replace both brushes at the same time. Note: Ozito Industries will not be responsible for any damage or injuries caused by the repair of the tool by an unauthorised person or by mishandling of the tool.
  • Page 11 CONTENTS 1 x Plunge Router PRG-632VK 1 x Centring pin 2 x Collets (6.35mm) 1 x Template guide 1 x Spanner 12 x Router bits 1 x Straight guide fence 1 x Instruction manual 1 x Dust extraction adaptor 1 x Kit box...
  • Page 12: Warranty

    PURCHASED FROM: ________________________________________________ DATE PURCHASED: ________________________________________________ 3 YEAR REPLACEMENT WARRANTY Your Ozito tool is guaranteed for a period of 36 months from the original date of purchase and is intended for DIY (Do it yourself) use only. WARNING The following actions will result in the warranty being void.

Table of Contents