Before using this product please give your special attention to “Safety Precautions” and “Important Information” (P. EN2 - EN4). Please keep this Operating Instructions for future use. these instructions. Contents Safety Precautions ........................... EN2 Important Information..........................EN4 Parts Names and Instructions ........................ EN5 Before Use..............................
Page 4
WARNING Do not plug or unplug the power plug with wet hands. Do not use the appliance if the power cord or power plug is damaged or the power plug is loosely connected to the outlet. Do not immerse the motor housing, power cord or power plug in water, or splash it with water and/or any liquid.
Safety Precautions Please make sure to follow these instructions. CAUTION Do not blend or place over 60 °C ingredients into the blender jug. Do not put any liquids or wet ingredients into the mill container. jug while the appliance is operating. Do not stretch the mill gasket to avoid deforming.
Parts Names and Instructions Blender Dry mill Accessory Mill container Scraper ● During blending, use the Blender jug scraper only through lid opening. Do not use with Mill gasket lid off. Working capacity Mill blade (approximately 1 000 mL) Mill container base Blender blade Rotary switch ON (continuous operation)
How to Use Blender Dry mill To disassemble To assemble Place the ingredients into blender jug, and then close the lid. Turn clockwise Turn anticlockwise Make sure the mill gasket is not damaged Attach blender jug to the motor housing. Align the △...
Cleaning and Care ● Unplug the appliance before cleaning. ● Clean the parts thoroughly after every use. Keep all parts clean and dry always. ● Do not wash any part of the appliance in the dishwasher. ● Do not use benzine, thinner, bleach, alcohol, nylon face of sponge, metal brushes or polish powder etc. ●...
Troubleshooting Check following points before calling or arranging for repair. Problem Cause and Action The blender jug / mill container is not set properly. Make sure to align the marks on blender jug / mill container and motor housing, then twist Even turn to "1"...
Need help?
Do you have a question about the MX-EP3111 and is the answer not in the manual?
Questions and answers