Advertisement
Quick Links
H-1HDMI-ATSC-IPLL
This guide also applies to models: H-2HDMI-ATSC-IPLL and H-4HDMI-ATSC-IPLL
Step 1: Connect and Login
HDMI 1
HDMI 2
Connect the NMS port to your PC using an ethernet cable
Open web browser and go to http://192.168.0.136
Login/Password: admin/admin
Step 2: Configure Encoders
https://thorbroadcast.com
HDMI 3
NMS
Select
"Encoder 1"
from the
main menu
Click "Apply" to
save changes
800-521-8467
HDMI 4
RF OUT
DATA
Recommended Settings:
Video Format: MPEG2
Video Bitrate: 18Mbps
Latency (Input/Output delay):
Normal: 800ms
Mode 1: 500ms
Mode 2: 300ms
Manual: 250 – 500ms
Note: These settings are TV
decoder dependent.
sales@thorfiber.com
Quick Setup Guide
Connect Power
Input Lock
must be Green
and showing
bitrate info
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Thor Broadcast H-2HDMI-ATSC-IPLL
Summary of Contents for Thor Broadcast H-2HDMI-ATSC-IPLL
- Page 1 800-521-8467 sales@thorfiber.com H-1HDMI-ATSC-IPLL Quick Setup Guide This guide also applies to models: H-2HDMI-ATSC-IPLL and H-4HDMI-ATSC-IPLL Step 1: Connect and Login Connect Power HDMI 1 HDMI 2 HDMI 3 HDMI 4 RF OUT DATA Connect the NMS port to your PC using an ethernet cable Open web browser and go to http://192.168.0.136...
- Page 2 Click Pencil Icons to modify parameters. Step 3: Configure Modulator (Channels and Frequencies) Select “Modulator” from the main menu Check box to enable channel Start Frequency 57MHz Recommended (See ATSC chart) Click “Apply” to save changes Step 4: TS Config (Transport Stream Selection) Click “Parse program”.
- Page 3 Step 4: TS Config (Program Customization) Click the program name for channel/sub- channel options Service Name can be changed Major/Minor Channel Numbers can be set to preference. (VCT must be enabled) Click “Apply” to save changes...
- Page 4 Step 4: TS Config (Virtual Channel Table) If VCT is ENABLED: The virtual channel numbers will Click “General” tab override the physical channel number. The TV will display the values set in the Program Information settings as the major channel number / minor channel number Check the box...
-
Page 5: For Example
Step 5: Output Settings (IP Streaming) Select “Output Settings” from the main menu Select top Pencil icon to edit all, Select Pencil icon on the same line to edit individually Status will show GREEN when enabled Check box to enable channel IMPORTANT: Streams are accessed via... - Page 6 Step 6: Save Configuration IMPORTANT: YOU MUST SAVE CONFIGURATION OR ALL Select “Configuration” CHANGES WILL BE LOST from the main menu AFTER RESTART Select the “Save” tab Press “Save Config” button Scan for more info: Confirmation message will appear briefly until saving is complete H-1HDMI-ATSC-IPLL Quick Setup Guide...
Need help?
Do you have a question about the H-2HDMI-ATSC-IPLL and is the answer not in the manual?
Questions and answers