Command access MLRK1-PDQ63 Insert Instructions page 3

device template and
to fully install exit device
plate
4.
Slide push pad asssembly back into housing completely.
all MLR connections
entary power to test MLR.
5.
Locate position, re-install Push Pad location screw, and tighten securely.
ushbar then apply momentary
6.
Test device. If needed, reset the Push to Set positiong following the steps on page 4.
24.5
e will emit (1) long beep
p has finished, release pushbar
retraction with badge/pin
24.5
s not to your liking, repeat
7.
Slide filler plate into housing and install plastic push rivet.
U.S. Customer Support
BEEPS 1-888-622-2377
MLR
MLR
Installation Instructions
REX (COM)
REX (N/O)
REX (N/C)
LM (COM)
LM (N/O)
LM (N/C)
3. IF FACTORY CALIBRATION IS
NOT TO YOUR LIKING, ENTER
CALIBRATION MODE
 Press and hold calibration button
 Apply momentary power
 The unit will emit (1) short beep
 Release calibration button
 The device is now in calibration mode
MLR TROUBLESHOOTING GUIDE
Visit our website for more details
EXPLANATION
Black
Gray
Bl
B
BEEPS EXPLANATION
2 Beeps
Over Voltage
3 Beeps
Under Voltage
4 Beeps
Failed Sensor
From
Step 2
5 Beeps Retraction or dogging failure
o i.e. swipe badge or enter pin
2. INSTALL LINK ROD
 Install link rod through link bar and
through MLR bracket
 Install retaining ring on both sides
www.commandaccess.com
MLR TROUBLESHOOTIN
1st fail: 5 beeps then immediat
2nd fail: 5 beeps with pause in
to retract again.
3rd fail: 5 beeps every 7 minut
To Reset: Depress then hold ba
MLR FIELD INSTALLATION I
5. REINSTALL FILLER PLATE
AND END CAP
 Ensure filler plate is flush with main rail
 Reinstall end cap
Canada Customer Support
SOLUTION 1-855-823-3002
5.
A


> 30V unit will shut
< 20V unit will shut d
Cont
1. RE
PLAT
 Rem
plat
 Disc
 Inst
3.
IN
