PANCONTROL PAN 200A+ Operating Manual page 4

9. Maintenance
Only authorized service technicians may repair the instrument.
If the instrument is malfunctioning, please test:
- Battery condition and polarity
- Condition of the fuse(s) if available.
- Condition of the test leads.
Changing the battery(s)
Replace the battery(s) when the battery symbol or BATT is displayed on the LCD.
1. Open the battery or fuse compartment with a suitable screwdriver.
2. Replace the battery. Mind the correct polarity.
3. Close the battery compartment.
4. Disposal of the flat battery should meet environmental standards.
Remove the battery if the device is not used for a long time.
Cleaning
If the instrument is dirty after daily usage, it is advised to clean it by using a humid cloth
and a mild household detergent. Prior to cleaning, ensure that instrument is switched
off and disconnected from external voltage supply and any other instruments
connected. Never use acid detergents or dissolvent for cleaning.
10. Guarantee and Spare Parts
This device is covered by the statutory warranty of 2 years after date of purchase
(according to purchase receipt).
Information on complaint processing can be found at:
www.pancontrol.at/complaints
In case of spare part requirement or in case of queries or
problems, please get in touch with your vendor or:
We strive to deliver the quality of the operating instructions that you rightly expect
from us.
If you would like to help us improve our translations, please make us aware of any
errors.
Feel free to write to us at: office@krystufek.at
4
IIEnglishII
Changes as a result of technical development,
as well as errors and printing errors reserved.
Vienna, 09-2022
© Dipl. Ing. Ernst KRYSTUFEK
GmbH & Co KG – 1230 Wien