Programming Chart - CDVI KCPROXWLC Quick Start Manual

KCPROXWLC
Stainless Steel Proximity Card Reader & Keypad

4] PROGRAMMING CHART

2 beeps are emitted
Red
LED ON
Programming Programming
illumination the output
keypad format
A0 A1
1 beep 1 beep
Green LED ON Green LED ON
Enter: Enter:
- The illumination
time in seconds or
- 1 = Wiegand format
"00" for a permanent
- 2 = Standard format
illumination.
Default Default
= 1
= 10 sec
1 beep = OK
1 beep = OK
Green LED ON Green LED ON
4 beeps = Error
4 beeps = Error
4
EN
To program the keypad,
connect the purple cable with
the black cable.
Switch the power supply off
then switch it back on.
Programming Programming the
the code lenght Bit format
A2 A3
1 beep 1 beep
Green LED ON Green LED ON
Enter: Enter:
- 26, 30 or 44
to define the Bit
- 4, 5 or 6 to specify
number of the
the number of digits.
Wiegand format
Default Default
= 5
= 26
1 beep = OK
1 beep = OK
Green LED ON Green LED ON
4 beeps = Error
4 beeps = Error
EN
Stainless Steel Proximity Card Reader & Keypad
Programming
Centaur or
Standard format
A4
1 beep
Green LED ON Green LED ON
Enter :
Enter:
- 0 = Decimal mode
- 1 = Hexadecimal mode
- 0 = Centaur mode
- 2 = ARK mode
- 1 = Standard format
Default
Default
= 1
1 beep = OK 1 beep = OK
Green LED ON Green LED ON
4 beeps = Error 4 beeps = Error
Disconnect the connection
between the purple and the
black cable to exit
programming mode.
KCPROXWLC
Kaypad Programming
programming the audible signal
A5 A6
1 beep 1 beep
Green LED ON
Enter:
- 0 = disable the
keypad beeps
- 1 = Enable the
keypad beeps
= 2
Default
= 1
1 beep = OK
Green LED ON
4 beeps = Error
2 beeps are emitted
5