Adjusting Loudness; Using Subwoofer Output; Using Non Fading Output; Using The High Pass Filter - Pioneer AVIC N1 - Navigation System With DVD player Operation Manual

1
Touch "BASS" or "TREBLE" in the
AUDIO menu.
2
Touch or to select the desired fre-
quency.
3
Touch "+" or "–" to adjust the bass or tre-
ble level.
Each time you touch "+" or "–" increases or
decreases the bass or treble level. +6 — –6 is
displayed as the level is increased or
decreased.

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1
Touch "LOUDNESS" in the AUDIO menu.
2
Touch "ON" to turn loudness on.
To turn loudness off, touch "OFF".
3
Touch or to select a desired level.
Each time you touch
the following order:
LOW (low) — MID (mid) — HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
• When the subwoofer output is on, you can
adjust the cut-off frequency and the output
level of the subwoofer.
1
Touch "SUB WOOFER" in the AUDIO
menu.
When PREOUT (the subwoofer controller
setting in INITIAL menu) is FULL, you can-
not select "SUB WOOFER".
➲ Rear speaker setting ➞ Page 87
2
Touch "ON" to turn subwoofer output on.
To turn subwoofer output off, touch "OFF".
3
Touch "REVERSE" or "NORMAL" to
select the phase of subwoofer output.
4
Touch "+" or "–" to adjust the output
level of the subwoofer.
+6 — –6 is displayed as the level is increased
or decreased.
or selects level in
5
Touch or to select cut-off frequency.
Each time you touch
frequencies in the following order:
50 — 80 — 125 (Hz)
Only frequencies lower than those in the
selected range are output from the sub-
woofer.

Using non fading output

When the non fading output setting is on, the
audio signal does not pass through navigation
unit's low pass filter (for the subwoofer), but is
output through the RCA output.
1
Touch "NON FADING" in the AUDIO
menu.
Only when PREOUT(the subwoofer control-
ler setting in INITIAL menu) is FULL, you
can select "NON FADING".
➲ Rear speaker setting ➞ Page 87
2
Touch "ON" to turn non fading output on.
To turn non fading output off, touch "OFF".
3
Touch "+" or "–" to adjust the output
level of the non fading.
+6 — –6 is displayed as the level is increased
or decreased.

Using the high pass filter

When you do not want low sounds from the sub-
woofer output frequency range to play from the
front or rear speakers, turn the HPF (high pass
filter) on. Only frequencies higher than those in
the selected range are output from the front or
rear speakers.
1
Touch "HPF" in the AUDIO menu.
2
Touch "ON" to turn high pass filter on.
To turn high pass filter off, touch "OFF".
3
Touch or to select cut-off frequency.
Each time you touch
frequencies in the following order:
50 — 80 — 125 (Hz)
When PREOUT (the subwoofer controller
setting in INITIAL menu) is SW, the HPF
function is effective for front speakers only.
or selects cut-off
or selects cut-off
83