Bosch PPH6A I1 A Series User Manual And Installation Instructions page 13

Accessories
Additional wok grid
Additional espresso maker
grid
Simmer cap
Simmer plate
7 Basic operation
7.1 Igniting a gas burner
The cooktop has automatic ignition of the burners.
WARNING ‒ Risk of fire!
Escaping gas may ignite.
If the burner does not ignite after 10 seconds, turn
▶
the control knob to the "Off" position and open the
door or window in the room. do not attempt to re-ig-
nite the burner for at least one minute.
In the event of the burner flames being accidentally
▶
extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least one
minute.
ATTENTION!
If you turn the control knob directly between position
and 1, malfunctions may occur.
For this reason, never turn directly from position
▶
to position 1 or vice versa.
Press the control knob for the selected burner and
1.
turn it anti-clockwise to the highest level.
Keep the control knob pressed in.
a For all of the burners, sparks are generated and the
flame ignites in the selected burner.
Wait a few seconds and release the control knob.
2.
→ "Safety system", Page 13
Turn the control knob to the required position.
3.
If the burner does not ignite, turn the control knob to
4.
the off position and repeat the steps described
above. This time, hold the control knob down for
longer (up to 10 seconds).
Description Use
¡ Only use on the multi-crown burner.
¡ Always use for cookware with a rounded
base.
¡ Recommended in order to extend the ser-
vice life of the appliance.
¡ Only use on the burner with the lowest
power setting.
¡ Use with cookware with a diameter smal-
ler than 12.
¡ Secure this above the economy burner
cap.
¡ Use only with the lowest power setting of
the burner.
¡ Place the cookware on the pan support,
never directly on the simmer cap.
¡ Use for cooking on a low heat.
¡ Place it on the pan support with the
bumps facing up – never place it directly
on the burner.
¡ Use the economy burner or the standard-
output burner. If you have multiple stand-
ard-output burners, use the rear burner.
Note:
Take the following information into account to ensure
that the appliance works correctly:
¡ The burner parts and the pan supports → Page 12
must be inserted correctly.
¡ Do not swap the burner caps around.
¡ The burner holes and grooves must be clean to en-
sure a correct flame.
→ "Cleaning recommendations", Page 15
7.2 Safety system
The safety system (thermocouple) prevents the flow of
gas if the flames accidentally go out. To ignite the
burner, you must activate the system that enables the
gas flow.
Ignite the burner without releasing the control knob.
1.
a The flame ignites.
Press and hold the control knob for a further four
2.
seconds.
7.3 Igniting a gas burner manually
In the event of a power cut, you can light the burners
manually.
Press the control knob for the selected burner and
1.
turn it anti-clockwise to the highest level.
Hold a lighter or a flame (lighter, match, etc.)
2.
against the burner.
7.4 Switching off a burner
Turn the control knob clockwise to ⁠ .
▶
Basic operation en
13