Page 1
Built-in gas hob PPH6A.B2.A PPQ7A.B2.A User manual and installation instructions [en]...
Page 2
PPH6A.B2.A PPQ7A.B2.A Component Pan support Control knobs Economy burner with an output of up to 1,00 kW Standard-output burner with an output of up to 1,75 kW High-output burner with an output of up to 3,00 kW Mini-wok multi-crown burner with an output of up to 3,50 kW...
Page 3
Safety en Futher information and explanations are available online: Table of contents 1.2 Intended use The appliance can only be used safely if it is INFORMATION FOR USE correctly installed according to the safety in- structions. The installer is responsible for en- Safety .............. 3 suring that the appliance works perfectly at its 1.4 Safe installation .......... 4...
Page 4
en Safety 1.4 Safe installation ¡ Before installing the appliance, check that the local conditions of the supplier are Follow these safety instructions when in- compatible with the appliance settings spe- stalling the appliance. cified on the rating plate (type of gas and ¡...
Page 5
Safety en Escaping gas may ignite. WARNING ‒ Risk of poisoning! ▶ If the burner does not ignite after Using the gas cooking appliance leads to a 10 seconds, turn the control knob to the build-up of heat, moisture and combustion "Off" position and open the door or window products in the room where the appliance is in the room.
en Installation instructions An ingress of moisture can cause an electric Strong temperature fluctuations may cause shock. the glass to break. ▶ Do not use steam- or high-pressure clean- ▶ When using the hob, avoid draughts and ers to clean the appliance. spilling cold liquids.
Page 8
en Installation instructions ¡ Seal the cut surfaces of wooden work surfaces with ¡ Any combustible construction above the cooktop a special glue seal to protect them from moisture. must be at least 650 mm above the top of the ¡ Any adjoining vertical wall surface situated within burner and no construction shall be within 340 mm 200 mm from the edge of any cooktop burner must above the top of the burner.
Page 9
Installation instructions en 2.4 Shield If the base of the hotplate can be touched, fit a protecting shield. ¡ The shield must be at least 10 mm from the lowest Screw the brackets supplied into the specified posi- part of the hotplate and must be capable of with- tion so that they can turn freely.
Page 10
en Installation instructions Turn the cooktop around and insert it into the re- Fill the gap between the work surface and the cook- cess. Insert the cooktop in the front of the recess. top using a suitable commercially available silicone adhesive. Turn the brackets and tighten them fully.
Page 11
Installation instructions en Wiring diagram Gas connection R 1/2 Observe the wiring diagram. Fit regulator (N. G.) or a test point (Universal LPG) ▶ directly to the R 1/2 connection. – Direction of gas flow is indicated on the rear of the regulator. –...
Page 12
en Installation instructions ¡ Check all connections for gas leaks with soap and With the tip of the screwdriver, push down on the water. DO NOT use a naked flame for detecting flexible rubber holder to access the bypass screw. leaks. ¡...
Page 13
Preventing material damage en Replace the nozzles using the appropriate wrench Reinstalling the appliance and tighten them carefully to guarantee the seal. Install the appliance components in reverse order. ▶ Checking if equipment is working Check that turning the rotary knob between the pos- ition for maximum power and the position for min- imum power does not cause the burner to go out or result in backfire.
en Environmental protection and saving energy 4 Environmental protection and saving energy 4.1 Saving energy Use a glass lid. ¡ You can see into the pan through a glass lid If you follow these instructions, your appliance will use without having to lift it. less energy.
Accessories vary from one appliance to another. When purchasing accessories, always quote the exact product number (E no.) of your appliance. → Page 19...
Page 16
en Cookware ¡ It is important to keep the appliance clean. Clean Hold a lighter or a flame (lighter, match, etc.) the ignition plugs regularly with a small, non-metallic against the burner. brush. Take care to prevent the ignition plugs from suffering any heavy knocks.
Cleaning and servicing en Tips Power Preparing meals ¡ Cooking tips level – When cooking soups, creams, lentils or chick- ¡ Starting the cooking process: Pasta, peas, add all of the ingredients to the cookware soups, creams, paella, pulses, rice pud- at the same time.
en Troubleshooting Clean using a non-metallic brush and soapy water. ATTENTION! Completely dry the appliance. If there are water The pan supports can be damaged if you clean them droplets or damp areas at the start of cooking, this in the dishwasher. may damage the enamel.
Service en Fault Cause and troubleshooting The gas does not ap- The gas supply has been shut off by the intermediate valves. pear to be flowing Open the intermediate valves. ▶ normally or there is The gas cylinder is empty. no gas being pro- Replace the gas cylinder.
Page 20
Expert advice for your Bosch home appliances, help with problems or a repair from Bosch experts. Find out everything about the many ways Bosch can support you: www.bosch-home.com/service Contact data of all countries are listed in the attached service directory.
Need help?
Do you have a question about the PPH6A.B2.A and is the answer not in the manual?
Questions and answers