Memory Modules - Compaq 234664-002 - ProLiant - ML330T02 Maintenance And Service Manual

Memory Modules

The server supports PC133-MHz ECC Registered SDRAM DIMMs. Additional DIMMs are
available to upgrade the memory. The server has four DIMM sockets located on the system
board.
The following guidelines must be followed when installing or replacing memory:
Use only PC133-MHz Registered ECC SDRAM DIMMs.
Memory modules must be industry-standard, 168-pin, PC 133-MHz Registered SDRAM
DIMMs. The SDRAM DIMMs must support CAS Latency 3 (CL=3).
Do not mix ECC and non-ECC SDRAM DIMMs. If different types of memory modules
are mixed, the system does not properly function.
NOTE: Memory modules do not need to be installed in pairs and can be installed in any sequence.
Figure 2-23: Memory module socket locations
Compaq ProLiant ML330 Generation 2 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: Mimic/Reaper Part Number: 234832-003 Last Saved On: 11/25/02 10:18 AM
CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that
you are properly grounded (earthed) before beginning any installation procedure. Refer to
"Electrostatic Discharge Information" earlier in this chapter for more information.
CAUTION: When handling a memory module, be careful not to touch any of the contacts.
Doing so may damage the module.
Removal and Replacement Procedures
1 2 3 4
2-31