Internal System Problems; Cd-Rom And Dvd Drive Problems - Compaq 234664-002 - ProLiant - ML330T02 Troubleshooting Manual

To a different slot on the same bus (not applicable for PCI Express)
a.
To a PCI, PCI-X, or PCI Express slot on a different bus
b.
To the same slot in another working server of the same or similar design
c.
If the board w
seated. Reinse
If y ou are testing a board (or a device that connects to a board):
4.
Test the board with all other boards removed.
a.
Test the server with only that board removed.
b.
CAUTION:
documentation for complete instructions before performing this operation or data loss could
occur.
Clearing NVRAM can resolve vari
5.
file if prompted. Have available any .CFG, .OVL, or .PCF files that are required.

Internal system problems

CD-ROM and DVD drive problems
System doe s not boot from the drive
Action:
Be sure the drive b
1.
If the CD-ROM drive jumpers are set to
2.
installed as device 0 on the cable so
Be sure no loose connections (on page 17) exist.
3.
Be sure the media from which you are attempting to boot is not damaged and is a bo
4.
If attempting to boot
5.
Refer to the operating syst
o
USB CD-ROM drive.
Be sure legacy support for a USB CD-ROM drive is enabled in RBSU.
o
Data read from the drive is inconsistent, or drive cannot read data
Action:
Clean the drive and media.
1.
If a paper or plastic label h
2.
and any adhesive residue.
Be sure the
3.
inserting a
orks in any of these slots, either the original slot is bad or the board was not properly
rt the board into the original slot to verify.
Clearing NVRAM deletes the configuration information. Refer to the server
ous problems. Clear the NVRAM, but do not use the backup .SCI
oot order in RBSU is set so that the server boots from the CD-ROM drive first.
from a USB CD-ROM drive:
em and server documentation to be sure both support booting from a
as been applied to the surface of the CD or DVD in use, remove the label
inserted CD or DVD format is valid for the drive. For example, be sure you are not
DVD into a drive that only supports CDs.
CS (the factory default), be sure the CD-ROM drive is
that it is in position for the server to boot from the drive.
otable CD.
Hardware problems 40