Compaq 234664-002 - ProLiant - ML330T02 Troubleshooting Manual page 123

Select a configuration option:
1. Enable OBDR
2. Exit
Audible Beeps: None
Possible Cause: A USB tape device that su
system.
Action:
Press 1 or 2.
1.
Pressing 2 exits the con
o
Pressing 1 starts the configuration. The following message appea
o
Attempting to enable OBD
Observe the configuration progress. The following error may appear:
2.
Error - USB tape drive not in Disaster Recovery mode.
Follow the onscreen directions:
3.
Remove power to USB
The following message should appear:
OBDR is now enabled for the
WARNING: A Type 2 Header PCI Device Has Been Detected...
The BIOS will not configure this card.
It must be configured properly by the OS or driver.
Audible Beeps: 2 short
Possible Cause: Only Type 0 and Type 1 Header
device will not work unless the OS or device driver properly configure the card. Typically this message
only occurs when PCI cards with a PCI to PCMCIA bridge are installed.
Action: Refer to the operating system documentation or the device driver information that ships with the
Type 2 PCI device
WARN ING - iLO 2 not responding. System health monitoring has been disabl
Audible Beeps: None
Possible Cause: The iLO and iLO 2 firmware is not responding. The iLO and iLO 2 Firmware may be
corrupt.
Action: If the iLO and iLO 2 firm
Maintenance CD.
WARN ING - Mixed Stepping Proce
Audible beeps: 1 long, 1 short
Possible cause: One or more 800-MHz front side bus speed processors have been initialized at 667-
MHz.
Action: Correct the processor configuration.
pports One Button Disaster Recovery (OBDR) is installed in the
figuration.
R for the attached USB tape drive...
drive and reboot.
.
ware is corrupt, update the iLO and iLO 2 firmware using the Firmware
ssors were detected. System cannot proceed.
attached USB tape drive.
PCI Devices are configured by the system ROM. The
rs
Error messages 123
ed.