5.25-Inch Drive - Compaq 133756-004 - Deskpro EN - 6550 Model 6400 Maintenance & Service Manual

4.8.1

5.25-Inch Drive

CAUTION: All removable media should be taken out of the drives before removing the drive from
the computer.
1. Prepare the computer for disassembly (Section 4.2).
2. Remove the computer cover (Section 4.6).
3. Rotate the drive cage to the upright position.
4. Rotate the power supply to the upright position.
5. Disconnect the audio, signal and drive power cables. The other end of the audio cable
should remain connected to the audio connector on the system board.
6. Pull the drive release latch away from the drive
7. Slide the drive toward the front of the drive cage
computer
To replace the drive, reverse the removal procedures.
✎
When replacing the drive, transfer the four screws from the old drive to the
new one. The screws take the place of drive rails.
3
.
1
.
2
, then lift the drive out of the
Compaq Deskpro EN Series of Personal Computers 4-11