Post Error Messages - Compaq 133756-004 - Deskpro EN - 6550 Model 6400 Service & Reference Manual

POST Error Messages

Screen Message
164-Memory Size Error
183-Invalid Processor
Jumper Setting
201-Memory Error
202-Memory Type Mismatch None
207-ECC Corrected Single
Bit Errors in DIMM/SIMM
Pair(s) X,X,... in Memory
Socket(s) y,y
213-Incompatible DIMM
Module in DIMM Socket(s)
X,X, X
* L = Long, S = Short
D-2 POST Error Messages
Continued
Beeps* Probable Cause
2S Memory configuration
is incorrect.
2S System board jumper
improperly set.
None RAM failure.
Memory modules do not
match each other.
2S Single Bit ECC error.
2S A DIMM module in DIMM
socket identified in the error
message is missing critical
SPD information, or is
incompatible with the
chipset.
Recommended Action
1. Run Computer Setup (F10
Setup) or Windows utilities.
2. Make sure memory module(s)
(if any) are installed properly.
3. Verify proper memory module
type.
Reset system board jumpers to
match processor and bus speeds.
1. Run computer Setup (F10
Setup) or Windows utilities.
2. Ensure memory and continuity
modules are installed correctly.
3. Verify proper memory module
type.
4. Remove and replace memory
module(s) one at a time to
isolate faulty module.
5. Replace the faulty memory
module(s).
6. If error persists after replacing
memory modules, replace the
system board.
Replace memory modules with
matched sets.
1. Verify proper memory module
type.
2. Try another memory socket.
3. Replace memory module if
problem persists.
1. Verify proper memory module
type.
2. Try another memory socket.
3. Replace DIMM with a module
conforming to the SPD
standard.
continued