Removing The Processor Cooling Shroud; Installing The Processor Cooling Shroud; Installing The Memory Module Cooling Shrouds - Dell POWEREDGE R805 Hardware Owner's Manual

Removing the Processor Cooling Shroud

1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 71.
3 Detach and remove the two memory module cooling shrouds on each side
of the processor cooling shroud.
4 Remove the expansion cards from expansion-card riser 2. See "Removing
an Expansion Card" on page 92.
5 Remove expansion-card riser 2. See "Removing Expansion-Card Riser 2"
on page 101
6 Lift the shroud upward and out of the system. See Figure 3-15.

Installing the Processor Cooling Shroud

1 Align the pin collars at the bottom of the processor cooling shroud with
the pins located on the two fan brackets. See Figure 3-15.
2 Lower the processor cooling shroud straight down onto the pins.
3 Reinstall expansion-card riser 2. See "Replacing Expansion-Card Riser 2"
on page 101.
4 Reinstall the expansion cards into the riser 2 board. See "Installing an
Expansion Card" on page 91.

Installing the Memory Module Cooling Shrouds

1 Align the pin collars at the bottom of the right ("B") memory module
cooling shroud with the pins located on the right side of the "B" memory
module slots. See Figure 3-15.
2 Lower the shroud straight down onto the pins and press down lightly to
latch the shroud to the processor cooling shroud.
3 Lower the left ("A") memory module shroud over the "A" memory modules
and press down lightly to latch the shroud to the processor cooling shroud.
4 Close the system. See "Closing the System" on page 71.
5 Reconnect the system to the electrical outlet and turn on the system and
attached peripherals.
96
Installing System Components