Replacing The Lom Daughter Card; Optical Drive; Removing The Optical Drive From The System - Dell POWEREDGE R805 Hardware Owner's Manual

Replacing the LOM Daughter Card

CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. See your Product
Information Guide for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.
1 Angle the LOM card so that its NIC connectors are positioned toward the
back-panel LOM card opening.
2 Straighten the card so that the cutouts on the side edges of the card insert
into the two support standoffs. See Figure 3-21.
3 Slide the card back slightly and align the front edge of the LOM card with
the two front plastic retention standoffs adjacent to the LOM system
board connector, and press down the side of the card until it is fully seated.
See Figure 3-20.
When the front of the card is fully seated, the plastic standoff snaps over
the edge of the card.
4 Reinstall all expansion cards in expansion-card riser 2. See "Installing an
Expansion Card" on page 91.
5 Close the system. See "Closing the System" on page 71.

Optical Drive

An optional slimline
tray that slides in the front panel and connects to the controller on the system
board.
NOTE:
DVD devices are data only.

Removing the Optical Drive from the System

CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. See your Product
Information Guide for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 71.
3 Disconnect the optical drive cable from the back of the optical drive tray.
DVD or CD-RW/DVD-RW
optical drive is mounted on a
Installing System Components
109