Using At Commands To Configure Your Modem - Multitech MultiModem ZPX Series Quick Start Manual

Using Global Wizard to Configure Your Modem
The Global Wizard configuration utility is recommended for computers running
Windows 2000 or newer.
1.
2.
3.
4.
5.
6.
7.
When Global Wizard announces that the parameters have been set, click Finish to
exit.

Using AT Commands to Configure Your Modem

Non-Windows users can configure the modem using AT commands. You must
enter these commands in your communication program terminal window.
1. Run your favorite communication program and open the program terminal
window.
2. To configure the modem for a specific country:
Type AT%T19,0,nn (where nn is the country code in hexadecimal format
Press ENTER.
The message OK displays.
3. To verify the change:
Type ATI9.
Press ENTER.
The country code is displayed in decimal format, as in this example:
The complete list of country codes can be found on the Multi-Tech
http://www.multitech.com/en_US/PRODUCTS/Categories/Device_Networking/
global_modems/configuration.asp
Multi-tech Systems, Inc.
Downloaded from Elcodis.com electronic components distributor
Insert the MultiModem system CD into the CD-ROM drive.
When the splash screen appears, click Initial Setup & Country Sel button.
Choose either:
a. Run Global Wizard from CD. This will not load the wizard onto your
hard drive, or
b. Install Global Wizard on the HD. This will install the wizard onto your
hard drive for future use.
The Global Wizard dialog box appears. Click Next.
The Wizard searches for your modem and identifies it. Click Next.
Select the country in which the modem will be used. Click Next.
Review your choice of country. If it is correct, click Next to configure the
modem.
Country
Euro/NAM
AT command
(hexadecimal)
AT%T19,0,34 (default)
Country code
(decimal)
52
Web site at:
7