Before Use; Checking For Leaks - sweeek. MAXIM Manual

STARTING UP
CONNECTING TO GAS
Firstly, make sure that there are residues on the opening key of the gas canister, nor the decom-
•
pressor, nor the burners nor their components. Check there are no insects or insect nests in any
of the apparatus' openings. An obstructed burner may cause a fire.
Clean the burner holes with a special cleaning product for gas burners.
•
Connect the end of the gas hose to the screw thread or the gas hose connector nozzle by using
•
a key or a tightening bolt. (not provided). If you replace the hose, repeat the safety instructions

before use.

Disconnect the compression valve of the gas canister when the BBQ isn't in use.
•
This apparatus must always be used in a well-ventilated area. It should not be used indoors or
•
in a garage.
Only use this barbecue outdoors, make sure that there are no leaks. Never check

CHECKING FOR LEAKS

Prepare a soapy solution with ¼ washing up liquid and ¾ water.
•
Make sure that all control switches are in the « OFF» position.
•
Connect the compression valve to the gas cylinder, checking all of the connections.
•
Put the soap solution through the hose and the connection points. If bubbles appear, there's a
•
leak and this must be repaired before use.
Check again after fixing the problem.
•
Close the gas valve on the canister once the test is finished.
•
If a leak is detected and it's not repairable, do not try to tap the leak yourself, get in touch with the
•
aftersales department directly.
PREPARE YOUR BARBECUE FOR FIRST USE
The juices of your food may contain flammable fats, we strongly
advise that you put a layer of sand, roughly 10­15mm in
depth in the inferior fat collecting tray, to facilitate the cleaning
process and the absorption of the fat. This tray must be cleaned
after each use.
15/11/2024
this with a flame. Use a soapy solution.
EN
29