Connecting To Phone Line; Checking For Dial Tone; Tone/Pulse Selection - VTech 2498 - VT Cordless Phone User Manual

Setup
IMPORTANT:
1. Do not dispose of a battery pack in a fire, the cell may explode.
2. Do not open or mutilate the battery pack. Toxic substances may be released
causing harm to eyes or skin.
3. Exercise care in hardling battery packs in order to prevent an accidental short
of the charge contacts, potentially causing the battery pack to overheat.
4. Do not dispose of this battery pack into household garbage. Please refer to
the information concerning proper battery recycling.

Connecting to Phone Line

Plug one end of the telephone line cord into the TEL. LINE jack on the back of the
Base Unit. Plug the other end of this cord into the wall jack.
The AUX jack can be used for connection to an answering device, fax or computer
modem.

Checking for Dial Tone

From Cordless Handset
After the battery is charged, press PHONE on the Handset. PHONE ON will
appear on the Handset display, and you will hear dial tone. If not, see In Case
of Difficulty.
From Base
Pick up the corded Handset or press the SPEAKER key. PHONE or
SPEAKERPHONE will appear on the Base display, and you will hear dial tone. If
not, see In Case of Difficulty.

Tone/Pulse Selection

Your VT2498 is preset for tone dialing.
See Base Menu - Setting Dial Mode for details.
CAUTION:
Use only the Vtech power supply provided with your telephone.
IMPORTANT:
FOR MAXIMUM PERFORMENCE OF YOUR
CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your Base Unit.
2. Install your Base Unit and Extension Handset
away from electronic equipment, such as personal
computers, television sets and microwave ovens.
3. In locations where there are multiple cordless
telephones, separate base units as much as
possible.
4. Install your telephone equipment away
heat sources and sunlight.
5. Avoid excessive moisture, dust or extreme cold.
2498-manual-output.p65
from
7 3/6/03, 9:33 AM