Check Battery Indicator; Connecting To Phone Line; Checking For Dial Tone - VTech ip5850 - 5.8 GHz DSS Cordless Phone User Manual

Setup

Check Battery Indicator

If you receive a check battery warning, it indicates one of the following:
1. There is no battery in your Handset. You'll need to install a battery into your
Handset (see Installation and Charge of Battery in Handset section on the
previous page.)
2. The battery has been installed incorrectly. Please
reinstall (see Installation of Battery in Handset)
and/or the diagram in the battery compartment on
the Handset.

Connecting to Phone Line

Plug one end of the telephone line cord into the jack at the bottom of the Base
Unit. Then plug the other end of the cord into the wall jack.

Checking for Dial Tone

After the battery is charged, press ON on the Handset. The word PHONE
will appear on the Handset display, and you will hear a dial tone. If not, see In
Case of Difficulty.
Tone/Pulse Selection
Your phone is preset for tone dialing. See Handset Settings for details.
CAUTION: Use only the VTech power supply provided with your telephone.
IMPORTANT:
FOR MAXIMUM PERFORMANCE OF
YOUR CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your Base
Unit.
2. Install your Base Unit and Extension Hand-
sets away from electronic equipment,
such as personal computers, television
sets and microwave ovens.
3. In locations where there are multiple
cordless telephones, separate Base
Units as far away as possible.
4. Install your telephone equipment away
from heat sources and sunlight.
5. Avoid excessive moisture, dust or ex-
treme cold.
9