Advertisement
Quick Links
Advertisement
Related Manuals for EnerSys Hawker Evolution
Summary of Contents for EnerSys Hawker Evolution
- Page 1 ATEX-Certified Batteries OWNER’S MANUAL www.enersys.com...
-
Page 2: Table Of Contents
CONTENTS Introduction .............. 3 Standard ..............4 Condition of Use ............4 Rating Data ............... 5 Safety Precautions ............ 5 Safety ................. 6 Service ............... 6 Handling ..............6 Taking Delivery of Your Battery ........ 7 Commissioning ............7 Maintenance ............. 7 Discharge .............. -
Page 3: Introduction
Proper instruction and training of all users must be ensured prior to any contact with the battery system. For service, contact your sales representative or call: EnerSys EMEA EnerSys World Headquarters EH Europe GmbH 2366 Bernville Road Baarerstrasse 18... -
Page 4: Standard
STANDARD & CONDITION OF USE These Evolution ATEX-certified batteries are batteries are designed for use in battery-powered ® certified for use in areas with risks of explosion due applications within hazardous areas, such as: to gas or dust. electric counterbalance, reach and pallet trucks, •... -
Page 5: Rating Data
RATING DATA & SAFETY Rating Data acid). Instead of a vent plug, a valve is used to 1. Nominal capacity C See type plate regulate the internal gas pressure, preventing the 2. Nominal voltage: 2.0 V x No of cells ingress of oxygen from the air and allowing the 3. -
Page 6: Safety
• Pay attention to the hazards that can be caused by batteries. Ignoring the operating instructions, and repairing with non-original parts will render the warranty void. All failures, malfunctions, and default codes of the battery, the charger, or any other accessories must be communicated to EnerSys service centre immediately. ®... -
Page 7: Taking Delivery Of Your Battery
BATTERY & COMMISSIONING Taking Delivery of Your Battery Do not carry out any of the following procedures The possibility of the insulation on the overall in a zoned area. Use special coding systems battery voltage leads being cut to expose the for maintenance-free batteries for the charging conductor is prevented by sleeving the insulation plug-and-socket devices to prevent accidental... -
Page 8: Discharge
MAINTENANCE & DISCHARGE Maintenance (cont.) Weekly are found, please contact an EnerSys Service ® Check all connections and take off leads for any frayed Representative. or worn insulation. If frayed wires or worn insulation If the discharge time of the battery is not sufficient,... -
Page 9: Recharge
If a hot battery is detected, it should be between +5°C and + 35 °C. Any use outside of taken out of the controlled zoned area and this range shall be approved by an EnerSys allowed to cool to ambient temperature. An ®... -
Page 10: Surrounding Area Conditions
HAZARDS & CARE Effect of Explosive Surrounding Atmosphere on Materials Area Conditions The apparatus is designed to cope with the The materials selected are not known to react intended surrounding area conditions. with any explosive atmospheres to which the apparatus may be subjected. Protection Against Hazards From Different Other Hazards... -
Page 11: Storage
STORAGE & MALFUNCTIONS Storage Malfunctions If batteries are taken out of service for a lengthy If malfunctions are found on the battery or the period, they should be stored in a fully charged charger, our service department should be called condition in a dry, frost-free room. - Page 12 © 2025 EnerSys. All rights reserved. Trademarks and logos are the property of EnerSys and its affiliates except for IEC, IECEX, UK ® CA, and CE, which are not the property of EnerSys . Subject to ® revisions without prior notice. E.&O.E.
Need help?
Do you have a question about the Hawker Evolution and is the answer not in the manual?
Questions and answers