Manually Setting The Printer's Ip Address - Dell 7330 User Manual

Manually Setting the Printer's IP Address

Note: Verify that your computer has a properly configured IP address for your network.
Contact your network administrator for more information.
If you are on a network without a DHCP server, or in an environment where the network
administrator assigns printer IP addresses, you can use this method to manually set the IP
address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you are
in a small office with a single PC and use a dialup modem connection, you can manually set
the IP address.
Information Required for Manual IP Addressing
Information
Internet Protocol (IP) address of the printer
Network Mask
Default Router/Gateway address
Using the Control Panel
To manually set the IP address:
1.
On the control panel, select
2.
Select
Connection Setup
3.
Select
Network Setup
4.
Select
TCP/IPv4 Setup
5.
Select
DHCP/BOOTP
6.
Select
IPv4 Address
7.
Enter the printer's IP address, and then press the OK button.
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents
a decimal number from 0–255.
If you are unsure, leave this blank; the printer
chooses an appropriate mask.
Router address is required to communicate with
the host device from anywhere other than the
local network segment.
, and then press the OK button.
Printer Setup
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button to select
, and then press the OK button.
Dell 7330 Mono Laser Printer
3-8
Configuring the Network Address
.
Off