Dell 7330 User Manual page 107

4. If prompted on the control panel, press the OK button to accept the paper size and type
that are shown, or proceed to step 7 to change them. If you are not prompted, proceed to
the next step.
5. Select
Paper Tray Setup
6. Select the tray you are configuring, and then press the OK button.
7. Select
Change setup
8. Select the appropriate type, and then press the OK button.
9. Do one of the following:
■ If your custom paper size is listed in the menu, select it, and then press the OK button.
■ If your custom paper size is not listed in the menu, select
press the OK button.
10.
If you selected New Custom Size
a. For
Short Edge
edge, and then press the OK button.
b.
For , use the Up Arrow and Down Arrow buttons to specify the long
Long Edge
edge, and then press the OK button.
c. If the control panel prompts you for the
Down Arrow buttons to select the direction you are feeding the paper into the tray,
and then press the OK button.
11. Either use the custom size as the document size in the application or select the appropriate
tray as the paper source.
Note:
If you later replace the custom size in a tray with a standard size, be sure to set the new
size in the control panel (or Auto Select for a size that is auto sensed).
, and then press the OK button.
, and then press the OK button.
, select the custom width and height:
, use the Up Arrow and Down Arrow buttons to specify the short
Paper Orientation
Dell 7330 Mono Laser Printer
4-48
Printing on Custom Size Paper
New Custom Size , and then
, use the Up Arrow and