Using The Hole Puncher; Setting The Default Hole Punching Option - Dell 7330 User Manual

Using the Hole Puncher

Depending on your region, the optional finisher is factory configured with either a 3-hole
punch or a 2- / 4-hole punch unit. To determine which option is installed on your printer, print
a Configuration Page from the control panel.
■ When the hole punch option is turned on, sheets that are sent to the Stacker Upper Tray or
the Stacker Lower Tray are punched.
■ When the hole punch option is turned off, no paper is punched.
■ When the printer detects that the punch waste box is full, a warning appears on the control
panel, and printing continues without punching.
To select hole punching in a supported driver:
Operating System
Windows 2000 or later
Mac OS X (version 10.3
and higher) driver

Setting the Default Hole Punching Option

The default hole punching option is selected through the control panel or through the
Embedded Web Server.
Control Panel
To set the default hole punching option on the control panel:
1.
On the control panel, select
2.
Select Paper Handling Setup
3.
Select Punch , and then press the OK button to toggle it on or off.
4.
If you have a 2-hole and 4-hole punch, then set
Embedded Web Server
1. Launch your web browser.
2. Enter your printer's IP address in the browser's Address field.
3. Click Properties.
4. In the left navigation tree, expand General and then click Printer Defaults.
5. Select On or Off in the Punch drop-down menu.
6. Select the desired number of holes in the Punch Holes drop-down menu.
7. Click the Save Changes button.
Steps
1. Select the Paper/Output tab.
2. Select Hole Punching or the number of holes in the Hole Punch
drop-down list.
1. In the Print dialog box, select Finishing Options from the
drop-down list.
2. Select the number of holes under Hole Punching.
Printer Setup , and then press the OK button.
, and then press the OK button.
Punch Holes
Dell 7330 Mono Laser Printer
4-54
Using the Hole Puncher
to 2 Holes or 4 Holes .