External Alarm - Creone LSC KeyBox KeyWin6 Keycontrol Series Installation Manual

External Alarm

When connecting your cabinet to an external alarm unit, you can get
two different alarm output, one for removing a key without acess,
and one for when the door is opened without access. The two alarms
is by default also registered in the Keywin 6 event log. To know more
KEYWIN6
Inställningar
I loggen registreras alla händelser, både från nyckelskåp och från KeyWin.
Edit cabinet
Skåpsöversikt
Alarm timout (s)
Administratörer
20
Backup & återställning
Avancerad
Alarm timout
20 s
Produktinformation
Creone
Larm öppen dörr
60 s
Main alarm activated
Main alarm for open door(s)
20 s
Main alarm for non allowed key taken(s)
60 s
External lock
Commnets
To connect an external alarm, follow the instructions below:
1. Connect the external alarm according to the diagram
above. Maximum load 60 volt /1 A.
2. When the alarm has been connected, log on to Keywin
6 and go to Settings. Mark the cabinet, go to edit and
advanced, tick the "Main alarm" button. (See below)
KeyWin6 - KeyBox SC manual Version 1.0.3. All and copyright reserved by Creone AB
7 DAGAR KVAR
Namn
Basic Avancerad
Boeing
Apple
Google
Volvo
Securitas
G4S
-
+
Cancel Remove Save
Återställ inställningar
Återställ inställningar
about this function and how it can be used, please see our KeyWin6
manual and our Help Center. Please note that your cabinet needs
to be connected to your KeyWin6 Portal in order to configure the
External reader settings for your cabinet.
Abonnemang Svenska Inloggad som Johan Wärnelöv
Administration Händelselogg Inställningar
Placering IP-adress
Default 160.144.189.141
Default 160.144.189.141
Default 160.144.189.141
Default 122.929.222.221
Default 160.144.189.141
Default 160.144.189.141
Nyckelöversikt Ominitera skåpet
3. This is also where you set the alarm timeout, you can
have an alarm in seconds for open door, and non allowed
key taken.
Spara Spara
23