Creone LSC KeyBox KeyWin6 Keycontrol Series Installation Manual page 13

5. Connect the power cable to the power supply.
7. If you purchased the Online IoT KeyWin6: Connect the cable
to from the battery backup to the main board according to the
image to the right. Note that the KeyBox door must be closed
when starting.
The KeyBox will start up which is indicated in the
display,<Starting>. Next the KeyBox will initiate each strip,
<init list> will be shown. When the KeyBox is started the first
time the DHCP network setting is activated, if the network
setting preparations are already performed, the display will
show a IoT pairing code. This means the KeyBox is ready
to connect to your KeyWin6 online portal. If the neccessary
network preparations is still to be performed the KeyBox
display will show <Connecting...> until internet access. The
physical part of the installation is now completed.
KeyWin6 - KeyBox SC manual Version 1.0.3. All and copyright reserved by Creone AB
6. Connect the TCP/IP cable according the diagram on the
below.
13