Rfid Reader - Creone LSC KeyBox KeyWin6 Keycontrol Series Installation Manual

RFID reader

When connecting an RFID reader to your cabinet, the users can login
to the cabinet with only their RFID badge/card or in combination with
RFID card + PIN. More information on how to activate this for the
users you find in our KeyWin6 manual. If the RFID reader not is con-
KEYWIN6
Inställningar
I loggen registreras alla händelser, både från nyckelskåp och från KeyWin.
Edit cabinet
Skåpsöversikt
Name
Administratörer
Demo
Backup & återställning
Avancerad
Name that will be visible in the administration view
Produktinformation
Amount of doors
1
Creone
IP or hostname
192.168.1.15
Location
Default
Language
English
Cardreader
Creone Desfire
Follow the instructions below:
1. Mount the RFID reader on the service door of the cabinet.
Turn of power on the cabinet by pulling the power cable on
the PCB (see page 15).
2. Connect the reader to the port on the PCB as per picture
above. Please note that our PCB provides both 12V and
5V, depending on which your reader requires.
3. Once reader has been connected correctly you can turn
on power again and check that the reader starts up.
4. Now you need to insert the reader to your KeyWin6 sys-
KeyWin6 - KeyBox SC manual Version 1.0.3. All and copyright reserved by Creone AB
Abonnemang
7 DAGAR KVAR
Basic Namn Advanced Placering
Boeing Default
Produktnamn
KeyWin5
Apple Default
Google Default
Volvo Default
Amount of lists
Securitas Default
2
G4S Default
-
+
Admin pincode
••••••••
Service pincode
•••••••
Avbryt Radera Spara
Återställ inställningar
Återställ inställningar
nected from the factory, follow the instructions below. Please note
that your cabinet needs to be connected to your KeyWin6 Portal in
order to configure the RFID reader setting for your cabinet.
Svenska Inloggad som Johan Wärnelöv
Administration Händelselogg Inställningar
IP-adress
160.144.189.141
160.144.189.141
160.144.189.141
122.929.222.221
160.144.189.141
160.144.189.141
Nyckelöversikt Ominitera skåpet
tem by login to KeyWin6 Portal ->SETTINGS -> ADVANCED
SETTINGS-> CARD READER.
5. Add your card reader settings and press save.
Spara
Spara
6. Go to SETTINGS->CABINET OVERVIEW and edit your cabi-
net. Now set the correct card reader settings and press
save.
7. To test card reader please see page 13, TEST CARDRE-
ADER.
21