Creone LSC KeyBox KeyWin6 Keycontrol Series Installation Manual page 19

Keycontrol strips
Below you can find the wiring diagram for the KeyControl strips in
your system. Strip cable from "CAN" should go to the left position of
the first strip in your system. Strip cable from "CAN RET" shall come
from the right position of the last strip in your system.
The same wiring is used for Keyrack with the obvious difference
that there is no door. If the cables are not connected according to
the diagram below, the display will either stop on <Starting> or a
KeyWin6 - KeyBox SC manual Version 1.0.3. All and copyright reserved by Creone AB
specific strip count. If so, you must turn off the power by pulling the
power cable on the PCB, connect the cables as specified below and
turn on power to the unit again, if you managed to set it correctly it
will boot up, init all the strips one by one and show the control unit
name or "Uninitialized".
DOOR
19