Operation; Stand-Alone Mode; Interconnecting Several Devices (Master/Slave Operation); Wireless Master/Slave Operation - EuroLite AKKU UP-4 QCL Spot QuickDMX MK2 User Manual

OPERATION

After you switch on the device with the ON/OFF switch the device starts running. The display indicates the last
operating mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone mode
via the control board and controlled via remote control (EUROLITE IR-38) and DMX signal.

Stand-alone mode

In the stand-alone mode, you can do without a controller. Disconnect the device from the controller and de-activate
wireless DMX and call up the desired setting. Please refer to the instructions under Control Board.

Interconnecting several devices (master/slave operation)

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled with the
master unit without the need for a DMX controller. The devices must be set to the corresponding operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button until Mas/Slav is indicated
on the display. Confirm with the ENTER button. Set "Slave" on all slave units with the UP and DOWN buttons.
Confirm with the ENTER button. Set "Master" on the master unit using the UP and DOWN buttons. Confirm
with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the DMX
output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been connected
in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller to the DMX input
of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate synchronously.

Wireless Master/Slave operation

Set the master device and each slave device to the same transmission channel. To do this, use the menu option ID
Set on the uplight.
To switch the transmission channel, press the Enter button. Wait until the next channel is displayed before pressing
the Enter button again.
The QuickDMX status indicator on the display shortly flashes R, G and B. It then lights up continuously according
to the set transmission channel.
The selected transmission channel is indicated by the status indicator.
Channel Color
Red R
1
2 Green G
3 Blue B
4 Yellow (red/green) R G
5 Cyan (green/blue) G B
6 Magenta (red/blue) R B
Choose the device which is to control the effects. This device then works as master device and controls all other
slave devices.
Set the master device to the desired mode. Set the slave mode (SLAVE) on every slave device. Please refer to the
instructions under Control Board.
34/44 00158399, Version 1.0