Connection With The Mains; Operation - EuroLite LED PFE-10 3000K Profile Spot User Manual

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED PFE-10 3000K Profile Spot starts running.
Focus/Dimmer
To adjust the focus, pease loose the knurled head screw of the lens tube.
To focus, push the lens tube back
and forth. When in the desired
position, tighten the knurled
head screw firmly.
International
L
N
17/20
Rotary
control to
adjust the
dimmer
intensity.
00101084.DOCX, Version 1.2