Operation Via Artnet - EuroLite LED IP Atmo Bar 10 User Manual

Operation via ArtNet

To be able to operate the device in ArtNet mode, it must first be set to ArtNet under the Control Mode menu
item (see Menu structure).
For use via appropriate lighting control software supporting ArtNet. The device can be configured via the
OLED and operating buttons.
Data Connection
The device uses a RJ45 data connection for connection to a computer or a previous or subsequent device.
To link all data ports the wiring can be carried out according to the following two installation methods.
Please refer to the instructions under Menu structure.
Only use UTP cable type CAT-5e or higher.
28/40
Interconnect the devices with network
cables. The Ethernet ports can be
used as inputs and outputs as
desired.
Connect the first device in the chain to
the computer's network card
(optionally through a network switch)
with a network cable.
If needed, cables up to 100 meters
long may be used (point-to-point
connection provided). Different
lengths are available as accessories.
00147939.DOCX, Version 1.0